hello ever one i resiliently bought a printer on ebay that is just like the afinibot here is the link if you want to see it. ( [www.ebay.com] ) there is some type of problem with the off set if i home a axis (x or y) it go's to the end stop then moves to the off set position but if i tell it to move lets say to x +50 it only moves to 50 from the end stop not 50 more it dose this on the x and y axis using its interface/display or repetier host im assuming that it is a setting some were

or the printer is in absolute vs relative mode..

send a G91 (relative mode) to the printer then try it

Tried it did not work my software on my laptop sends g90 then G1 then G91
I'm printing a part to do a way with the offset