Print stuck to glass
Posted by stan510
|
Print stuck to glass November 13, 2016 08:09PM |
Registered: 7 years ago Posts: 17 |
|
Re: Print stuck to glass November 13, 2016 08:27PM |
Admin Registered: 13 years ago Posts: 7,000 |
|
Re: Print stuck to glass November 13, 2016 09:15PM |
Registered: 7 years ago Posts: 17 |
|
Re: Print stuck to glass November 13, 2016 10:40PM |
Registered: 7 years ago Posts: 17 |
|
Re: Print stuck to glass November 14, 2016 01:13AM |
Admin Registered: 13 years ago Posts: 7,000 |
well it sounds like your glue is far to sticky...
get a large wood chisel (with un damaged head) slide the flat of the blade on the glass and attempt to get under the print, once under carefully twist
You may need to do this from several corners of the part.
Be careful, don’t slice your fingers off!
get a large wood chisel (with un damaged head) slide the flat of the blade on the glass and attempt to get under the print, once under carefully twist
You may need to do this from several corners of the part.
Be careful, don’t slice your fingers off!
|
Re: Print stuck to glass November 14, 2016 01:55AM |
Registered: 7 years ago Posts: 129 |
|
Re: Print stuck to glass November 14, 2016 12:26PM |
Registered: 7 years ago Posts: 17 |
|
Re: Print stuck to glass November 14, 2016 01:02PM |
Registered: 8 years ago Posts: 165 |
|
Re: Print stuck to glass November 15, 2016 05:06PM |
Registered: 7 years ago Posts: 17 |
Elmer's all purpose clear glue stick. I'm using PLA filiment.
I found that placing the glass on my stove element (electric stove) and heating a bit frees it up without danger of melting the item. I just push on it with something while heating and it slides off, usually in less than a minute.
I found that placing the glass on my stove element (electric stove) and heating a bit frees it up without danger of melting the item. I just push on it with something while heating and it slides off, usually in less than a minute.
|
Re: Print stuck to glass November 15, 2016 08:38PM |
Registered: 8 years ago Posts: 165 |
I use that same combination, except glue is made by Scotch.
Prints on the "fresh" glue layer usually sits really well, that i might even need some force to remove it even after it cools down.
But the next 2-4 prints it will pop up after it cools down to room temperature. eventually the glue will fail and needs to be washed off and reapplied.
Maybe tap the bottom of a print gently with a small hammer? Or screwdriver or wrench?
(Don't hit the glass, just slide along the glass surface towards the print)
Prints on the "fresh" glue layer usually sits really well, that i might even need some force to remove it even after it cools down.
But the next 2-4 prints it will pop up after it cools down to room temperature. eventually the glue will fail and needs to be washed off and reapplied.
Maybe tap the bottom of a print gently with a small hammer? Or screwdriver or wrench?
(Don't hit the glass, just slide along the glass surface towards the print)
|
Re: Print stuck to glass November 15, 2016 10:52PM |
Registered: 8 years ago Posts: 430 |
Sorry, only registered users may post in this forum.