Welcome! Log In Create A New Profile

Do I need any driver?

Henrik Jansson

Do I need any driver?
November 16, 2016 01:45PM

Registered: 8 years ago
Posts: 12

I have reprap prusa i3 and RepetierHost. Is this enough or do I need to install some kind of driver also? Or is RepetierHost the driver?

Reply Quote

Supermec

Re: Do I need any driver?
November 16, 2016 02:04PM

Registered: 8 years ago
Posts: 181

You need the USB driver for your printer installed in Windows (if that's what you use). If the driver is installed you will see a COM port in device manager.

You should set the baud rate to match the printer and set the COM port to Auto so that it detects the COM port on the printer.

Edited 1 time(s). Last edit at 11/16/2016 02:06PM by Supermec.

Reply Quote

Henrik Jansson

Re: Do I need any driver?
November 16, 2016 02:11PM

Registered: 8 years ago
Posts: 12

No, sorry, I forgot to tell that I use Linux Mint 17.
Where do I find the driver and what is it called?

Reply Quote

obewan

Re: Do I need any driver?
November 16, 2016 05:26PM

Registered: 8 years ago
Posts: 759

Install the arduino software, this will install the usb driver.

Reply Quote

Dust

Re: Do I need any driver?
November 16, 2016 06:42PM

Admin
Registered: 13 years ago
Posts: 7,124

under linux just open up a consol and cat -f /var/log/messages (or syslog, what ever your distro uses)

Then plug in the usb cable, it will tell you what it does with it

It should create a serial device for you.

If not then you need to identify your electronics and what usb 2 serial chip it uses and go from there