So I tried tuning my motors and failed by shortening it out. I replaced the ramps board with a different companies ramps board then the Folger Tech printer came with. Z seems to be working fine but, x and y don't stop at the endstops when I home X and Y. I remembered that I switch some numbers in the trigger function when I built this printer. So could the different company ramps board be different then the Folger Tech ramps board and I need to change trigger function or is there something else wrong.
Never mind I figure it out by use m119 trigger and realized the x and y were switched
Edited 1 time(s). Last edit at 11/18/2016 04:58PM by shaol.
