Reprap Prusa i3 Rework Ready Marlin Firmware March 05, 2017 10:52AM |
Registered: 7 years ago Posts: 2 |
Re: Reprap Prusa i3 Rework Ready Marlin Firmware March 06, 2017 10:35PM |
Registered: 10 years ago Posts: 477 |
Re: Reprap Prusa i3 Rework Ready Marlin Firmware March 14, 2017 06:24AM |
Registered: 7 years ago Posts: 2 |
Hello, SteveQuote
SteveRoy
If it's a scratch build then you need to figure out most of the values yourself.
Depends on pulley size, belt type, z-axis threaded rods, extruder type etc etc
These are my notes from a recent build:
[www.instructables.com]
Steve