Hi
I am new here and joined the forum for help please. I am struggling with the auto bed leveling. The printer homes in the middle and after that it probes 9 points and begin to print. The problem is if i make the Z offset so that the print is perfect the one corner is printing to low. It is like the leveling does not compensate enough, i can see the z motor working but like i say it is not enough. I have glass on the build bed and i checked and made sure i did not have a warped bed
Starting code:
G28
G29
My configuration.h is attached
I am using Marlin Bugfix that came out the 12th May
