I have a CTC clone, I don't have access to the firmware but I need to change the axis steps because my prints come out undersize.
Is there another way to change the steps ??

Also when I go to Prepare/Preheat ABS-PLA bed the cooling fan comes on 100% which is the opposite to what is required. Can i disable the fan ??

I know I can change these manually in the control lcd but its a pain

Eddy

Edited 1 time(s). Last edit at 11/02/2017 05:32AM by eddy99.

If eeprom is enabled in firmware you could use a host like repetier or matter control to edit these values

Thanks obewan.
I have sorted it by putting a couple of M92 lines in my printer G code