I have a CTc RepRap Prusa i3 DIY printer. It has a 2560 Rev A board. Using an SD card it works very well, but I can not get my PC to communicate with the printer. I have followed the advice offered in every forum,but to no avail. Can anyone suggest a method of connecting the printer to the PC with ongoing checks to indicate any problems.?

Try this it has worked for me.

[www.thingiverse.com]

Hi
try this i have the same printer works a treat with no problems

[www.repetier.com]

Edited 1 time(s). Last edit at 12/18/2017 12:53PM by Thereaper.