Welcome! Log In Create A New Profile


drv8825 problem

Posted by malio77 
drv8825 problem
June 28, 2018 04:15AM
I have my drv8825 motor drive, and I have a problem with it. I installed the motor driver on the ramps card, but when the 3d printer starts to print, it prints the track a bit smaller than normal and starts at any point on the table, not the origin.What is that solution
Re: drv8825 problem
June 28, 2018 06:32AM
You have to double up the steps/mm for drv8825 drivers or remove MS3 jumper to config 1/16 instead of 1/32 microstepping.
Sorry, only registered users may post in this forum.

Click here to login