I'm trying to enable bed autoleveling on my folger2020. To that end, I would like to flash my folger2020 with original Marlin firmware.
Has anyone done this? Is there anything to change from stock Marlin besides what you do for a normal printer anyway? ie, thermistor, steps, etc.
Basically anything needed outside Configuration.h or Configuration_adv.h ?
(Another reason for using stock Marlin with folger2020 is the provided folger2020 firmware doesn't compile....but that's an aside)
Edited 1 time(s). Last edit at 08/03/2018 05:44PM by foul_owl.
