Did anyone tried to install MMU2 on printer whihc is not Prusa?

no, its has a separate controller and the firmware required to talk to it is only in prusa mk2.5 or mk3 firmware (so far)

there are prusa clones which works with prusa firmware.

yes, and so far all of them are pre mk2.5 level.

mk2.5 needs the mk52 heated bed, bondtec gears, filament sensors and v2 pinda probes....

mk3 also needs Trinamic steppers on a Einsy Rambo 1.1a and is 24volt based with power panic pcb, and 5v fans and 3030 tslot based frame...

or you rewrite the firmware...

Edited 1 time(s). Last edit at 10/29/2018 03:19AM by Dust.

Almost all of that clones already have

link? as ive not seen any (other than one off DIY jobs)

Edited 1 time(s). Last edit at 10/29/2018 03:35AM by Dust.

there are mostly DIY
but controllers support all of that