Hi,
I was tweaking my printer yesterday with one of the awesome prints from thingiverse. The way i was adjusting it was by using the LCD:
The question is:
Where I find the Flow rate which is dialed in at 200 on the LCD and my slicer extrusion multiplier is .94. How would i go about calculating the new extrusion multiplier.
Speed, on this setting I dialed the speed in at 80 rather than 100. How would i set this under the speed settings in the slicer.
Where these values are adjusted on the LCD, would the values for the flow and speed be % or in mm i.e. 200mm for flow rate.
Thanks
PS If i was to buy the license for simplify3d, would the same license work on linux, or would i have to buy another one for linux, i.e. a difference license for windows/linux
