Hello,I am brand-new to this forum and 3d printing so if I am violating any protocols I apologize in advance. If my questions seem stupid , it comes with being brand-new.
I have an Anet a8 and the
home-offset-routine does not work. This printer appears to feel my bed's left side is 20mm is closer than it is. I am unable to change the settings. After I do the
auto-home-all routine and go to move the X axis the it starts showing a negative value . The y axis also shows a negative value. How do I delete these negative values. None of the tutorials on YouTube show negative value showing up for either the x or y axis.
While there has been no smoke or fire, this machine has endured a lot "beginner ophs" in its assembly. Before I starting replacing components, I would like to make sure there is no another route.
Any suggestion?