Stringing

Hello,

I have finished my fisher 1.0 build, and, I would say, the design quality is really great.

I have 3 x i3, one Wilson, and this is my first delta printer.

The print precision is awesome, however I have stringing issues with my prints (like everybody else it seems).

I have played, from the slic3r config bundle, with these parameters :

- retraction length : from 3.2 (default) to 10 mm
- retraction speed : tried to increase it to 60, but the extruder is not really happy with it, so back to default
- temperature : from 182 to 210, same results (esun pla)
- wipe nozzle : on and off

Still the same results, with hairy prints...

Any thoughts anyone ?

Thank you !

Try another filament. I have tried all of that with the same results.

Yep, I have a roll of Colorfabb PLA/PHA, I will give it a shot !
Keep you updated...

For the record I am currently using the following settings:

200C on eSun, 205 first layer then 200 on Velleman (all colours so far)

0.5mm coast
4mm retraction distance, but 3.5-6mm all seems fine
50mm/s retraction speed
0.5mm extra restart
No wipe