Calibration Speed. January 14, 2016 12:11PM |
Registered: 8 years ago Posts: 301 |
Re: Calibration Speed. January 15, 2016 03:01AM |
Registered: 10 years ago Posts: 14,672 |
Re: Calibration Speed. January 15, 2016 03:27PM |
Registered: 8 years ago Posts: 301 |
Quote
dc42
Assuming you are using a version of my firmware fork that isn't too old, the travel speed between probe points is set by the T parameter of the M558 command.
Re: Calibration Speed. January 15, 2016 03:45PM |
Registered: 10 years ago Posts: 14,672 |
Re: Calibration Speed. January 17, 2016 12:10PM |
Registered: 8 years ago Posts: 301 |
Quote
dc42
If normal travel speed is 200mm/sec, that's 12000mm/min. So use T12000 or lower. I use M558 P1 X0 Y0 Z0 H3 F300 T12000 on my large delta, but on a Fisher you need P4 not P1.