Just broken my first 3D printed part!!! January 06, 2016 10:44AM |
Registered: 8 years ago Posts: 75 |
Re: Just broken my first 3D printed part!!! January 06, 2016 01:55PM |
Registered: 8 years ago Posts: 301 |
Re: Just broken my first 3D printed part!!! January 06, 2016 05:15PM |
Registered: 8 years ago Posts: 75 |
Re: Just broken my first 3D printed part!!! January 06, 2016 05:51PM |
Registered: 8 years ago Posts: 301 |
Re: Just broken my first 3D printed part!!! January 07, 2016 05:21AM |
Registered: 8 years ago Posts: 75 |
Quote
DADIY
That's handy. But It's a good reminder for everyone to print some spares as soon as they can.
Tonight I was trying to get cura working (again) and it seems to be starting at z0 so the extruder can't get any filament out, In the few seconds before I stopped it I managed to block the nozzle and break the filament halfway down the Bowden tube. So tomorrow's job is to remove the tube from the heat sink and sort the blockage. I'm tempted to splash another 99p on a pneumatic inline connector in case it happens again.