Prints warping March 01, 2016 04:33PM |
Registered: 8 years ago Posts: 26 |
Re: Prints warping March 02, 2016 07:53AM |
Registered: 8 years ago Posts: 17 |
Quote
pixelseventy2
Hi. Whenever I print a larger model, particularly one with a significant flat volume, they nearly always lift and warp at one or two edges. For example, this Raspberry Pi case, it lifted in one corner quite a bit. If I put a brim of 3mm on things like this, it doesn't lift as much, but it still does. Is there anything I can do besides adding an even larger brim?
Not sure if it's related, but how do people clean the buildtak bed?
Thanks
Re: Prints warping March 02, 2016 03:58PM |
Registered: 8 years ago Posts: 26 |
Re: Prints warping March 02, 2016 04:42PM |
Registered: 8 years ago Posts: 301 |
Re: Prints warping March 27, 2016 02:57PM |
Registered: 10 years ago Posts: 62 |