Welcome! Log In Create A New Profile


heater cartridge on its way out??

Posted by jimmyjim 
heater cartridge on its way out??
March 30, 2017 11:03PM
The new belts are now in, the little Fisher is back to perfect prints!

I've noticed that I'm having to print higher temps now. I run "0" in the slicer, then manually set the temp as required, it was 210, when I started, I'm now running 245/250!

I've had a quick look, it appears to be 19v and 60W, can't find anything!

Any advice, please.

Cheers Jim
Re: heater cartridge on its way out??
March 31, 2017 02:43AM
It's more likely to be a problem with the thermistor. Check that the wires are not shorting against the heater block.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
Sorry, only registered users may post in this forum.

Click here to login