Welcome! Log In Create A New Profile

Repsnapper

NelsonRap

Repsnapper
April 15, 2011 03:02AM

Registered: 13 years ago
Posts: 862

Anyone in the top of the South Island have any success printing with a Mendel and Repsnapper software (Arduino doesn't work with Gen 6 electronics)? Just running up my Mendel and can't get successful prints they start off fine then go to pieces halfway through.

Any help gratefully appreciated

Gary

__________________________________________________________________________
Experimenting in 3D in New Zealand

Reply Quote

NelsonRap

Re: Repsnapper
April 26, 2011 04:26PM

Registered: 13 years ago
Posts: 862

Well, have finished calibrating my Mendel and hope to do my first print today

__________________________________________________________________________
Experimenting in 3D in New Zealand

Reply Quote

Diecast dude

Re: Repsnapper
April 27, 2011 03:15AM

Registered: 14 years ago
Posts: 43

Excellent! Best of Luck.

Reply Quote

NelsonRap

Re: Repsnapper
May 07, 2011 04:47PM

Registered: 13 years ago
Posts: 862

I'm getting there now, once I sorted out the E steps to the Z axis I was away, although my prints aren't of really good quality yet

__________________________________________________________________________
Experimenting in 3D in New Zealand