Wellington project.
November 08, 2009 04:23AM
Just letting people in the greater Wellington area know that I've got most of the drivers written on my ARM 32 bit microcontroller based controller board, and I'm getting close to being able to run g-codes.

If anybody's interested, this hardware base is pretty versatile and without many of the limitations of the current reprap generation equipment.

I'm not doing any work to perfect the mechanics at this stage, my current focus is software.

Graham.


My CNC/extruder creation: [grael-minifactory.blogspot.com]
Re: Wellington project.
November 16, 2009 09:29PM
Awesome. Should make porting to a Maple board a lot easier.

Hmm, will it run on an Android phone? smiling smiley

Vik :v)
Re: Wellington project.
November 17, 2009 02:02AM
Actually, I was thinking of asking for some volunteers to port it to the ENIAC platform smiling smiley
Re: Wellington project.
December 12, 2010 11:18PM
Hi guy's <---- newbe here lol I just found out there are peeps in welly with this stuff - Kewlaz! is there like a club or a monthly meeting or group on facebook etc that i can join ?
Re: Wellington project.
December 13, 2010 12:30PM
You can try searching for the Wellington MakerSpace, unfortunately I belong to the Auckland MakerSpace: Tangleball
Re: Wellington project.
December 13, 2010 10:43PM
Hi Grogyan,
Thanks for that - i did check it out and applyed to become a member , hopefully i'll get to go check them out yawning smiley)

johneb.
Re: Wellington project.
April 24, 2011 10:03PM
grael Wrote:
-------------------------------------------------------
> Actually, I was thinking of asking for some
> volunteers to port it to the ENIAC platform smiling smiley



I also think so.


watch movies online free
Sorry, only registered users may post in this forum.

Click here to login