Prints too small December 14, 2014 11:41PM |
Registered: 9 years ago Posts: 118 |
Re: Prints too small December 15, 2014 02:24AM |
Registered: 9 years ago Posts: 118 |
Re: Prints too small December 15, 2014 04:28AM |
Registered: 10 years ago Posts: 26 |
Re: Prints too small December 15, 2014 04:14PM |
Registered: 10 years ago Posts: 33 |
Re: Prints too small December 15, 2014 05:50PM |
Registered: 9 years ago Posts: 118 |
Re: Prints too small December 16, 2014 02:40AM |
Registered: 9 years ago Posts: 118 |
Re: Prints too small December 17, 2014 12:47AM |
Registered: 9 years ago Posts: 118 |
Re: Prints too small January 03, 2015 01:51PM |
Registered: 15 years ago Posts: 242 |
Quote
clogs51
I'm back to that horrible grating noise when I home all axes though.
I looked hard at the x drive pulley,and it's not actually moving when it gets to the endstop,just sits there graunching away for 3-4 seconds.
The Y axis goes even longer.
To add insult to injury,it won't print again now.Rats!I'll probably have to reset the z-endstop in config.h again,because m119 now shows
both z min and max endstop triggered.That can't be right.
My extruder had the longer 44(?)mm motor,which meant i had to devise an adapter to fit the hotend.
This resulted in a rather wobbly extruder,so i have ordered a 34mm long motor from makershop.