PLA Flex off trade me .. trail
December 26, 2014 08:42PM
Hi I tried some PLA Flex that was on sale on trademe from Sandbrooks in manukau , ( unbranded) so "you pays your money and takes a chance" after reading on many forums about the Extruder temp needing to be around the 230 deg's, I discovered that 185 to 190 deg's gave me the best results..

Edited 3 time(s). Last edit at 12/26/2014 09:18PM by moth4017.
Re: PLA Flex off trade me .. trail
December 26, 2014 10:25PM
That stuff looks the same as I get from Hobbyist.PLA should not need more than 195 deg.C,
you might have got confused with ABS,which does need higher temps.
Re: PLA Flex off trade me .. trail
January 03, 2015 12:21PM
Without popping a thermocouple sensor in the same heat envelope as your hot end and independantly verifying your temperature is acurate....
Re: PLA Flex off trade me .. trail
January 04, 2015 08:59PM
@ greal

I check the hot end with a thermo couple so its with in +/- 3 Deg
Sorry, only registered users may post in this forum.

Click here to login