I'm still struggling with this. Running a print on my Folger Kossel without a G29 line, printing on the mechanical calibration, I get okay results. Still think it would be more expedient to mount the bed on springs, but what do I know? If run with a G29, it goes through the big song and dance routine of probing the bed, and then either prints the same as without, or at an even worse tilt. Can anyone who actually knows how Marlin works answer this question: Exactly what data is gathered by the Z probe routine, and what exactly does Marlin do with that data?
To clarify, I'd like book, chapter and verse. What lines of code in which files deal with the mesh data?
Edited 1 time(s). Last edit at 11/01/2016 03:00AM by av8r1.
