Hello,
So i have a few TMC262 drivers, the driver is not the normal shield that people use but a high powered breakout board.
[
www.trinamic.com]
I see the firmware has support for this chipset but when i look at it i am a bit confused.
Seems like it only uses dir, step, and chip select. i dont see where it calls for the sdo, sdi, and sck pins.
The config also appears to not have any of the fancy options or functions like the 2130 chips is this correct?
So i was wondering if anyone that has used this can let me know what features the current version of marlin supports when running on a ramps 1.4 with arduino mega.
