Hey guys and girls, I am curently gambeling arround with more TMC2130 Drivers, its only on the Bench but maybe you could follow me:
ich got TMC2130's including SPI and DIag0 on all 6axis (on my new printer this will be XYZ X2 E0 E1 XYZ are working fine, i know how to asign X2 etc thats not new,
but on TMC2130 Debug M122 I ony get status reports on XYZ never on X2 or any of the extruders,
If i set current via
SENDING:M906 X I1 500 // it always reports (like it would work) back current of all the other axis, but not of the "uncommen ones"
X driver current: 800
Y driver current: 900
Z driver current: 900
This is M122 output:
SENDING:M122
X Y Z
Enabled false false false
Set current 800 900 900
RMS current 795 887 887
MAX current 1121 1251 1251
Run current 25/31 28/31 28/31
Hold current 12/31 14/31 14/31
CS actual 12/31 14/31 14/31
PWM scale 128 128 6
vsense 1=.18 1=.18 1=.18
stealthChop true true true
msteps 16 16 16
tstep 1048575 1048575 1048575
pwm
threshold 0 0 0
[mm/s] - - -
OT prewarn false false false
OT prewarn has
been triggered false false false
off time 5 5 5
blank time 24 24 24
hysteresis
-end 2 2 2
-start 3 3 3
Stallguard thrs 8 8 8
DRVSTATUS X Y Z
stallguard
sg_result 0 0 0
fsactive
stst X X X
olb X X
ola X X
s2gb
s2ga
otpw
ot
Driver registers: X = 0xE0:0C:00:00
Y = 0xE0:0E:00:00
Z = 0x80:0E:00:00
could someone tell me if ther is just not feedback on this (X2 etc) or am I mistaking somwere?
btw tm2130 lib is form 5.8.2018 so thats new.,
