Hello all,
I wonder if someone can point me in the right direction? I've attempted to use Marlin bugfix-2.0.0 twice on my Anycubic Kossel Linear Plus, once on the Trigorilla board and again with a BigTreeTech SKR v1.3 and I get the same issue. If I start DELTA AUTO CALIBRATION the printer asks for the probe to be DEPLOYED and then it continues to probe the bed for it's first iteration (AC Check). Then it homes all axes to prepare for second run, probes the bed near 0,0 (centre) the moves to the X tower but doesn't touch down so to speak, and prompts for the probe to be removed. As soon as acknowledged Calibration halts saying PROBING FAILED.
I've tried setting the delta height to 400 etc. but still no luck, I'm sure I've missed a setting somewhere but unsure where.
Ever hopeful
Thank you
It's not an addiction... it's an obsession
