I have delta and recently upgraded to a 32bit board (SKR 1.3) and also to TMC2130 (and I have 256 micro-stepping). No matter what, when I run my usual printer calibration routine (G33 P1, P2, P5, P10) it always randomly fails. It usually fails when probing near the towers. I have no idea what to do with it because it is sometimes able to finish (eg. the P2 command). And when I run it for the second time it fails.
It actually finished once (but I that was pure luck), and I was able to use the printer in that state until yesterday when I wanted to do some cable management and I had to take it apart.
Any ideas anyone?
Error image and video:
[
imgur.com]