Marlin bugfix-2.0.x Additional Preheat settings

I was able to add additional Preheat settings to the Marlin bugfix-2.0.x branch.
By default PLA and ABS are already defined.
I have added HIPS, PP, PET, FLEX and NYLON definitions.
The fork can be found here: Marlin bugfix-2.0.x fork

To see the changes I have made, look HERE.

[github.com]

Edited 3 time(s). Last edit at 12/12/2019 07:16PM by AJMartel.

Thank You AJMartel...

I had added Preheat settings in Config.h for HDPE, TPU and PETG, but they weren't showing up when I flashed to my Ender 5...

I assume these additional changes to Language_en.h are machine agnostic?!

Perhaps this instruction should be added into the std Config.h file so that others who want to do this won't have to go searching for the extra code like I did?

A

[Edit: just going back and doing everything, not half a job!! :-( ]
[Final Edit: OK... ALL changes made. Upload successful... new menu items in place. Thanks again. Would never have been able to work all that out!]

Edited 3 time(s). Last edit at 03/23/2020 06:16PM by Vidius.

The following link should open to show you all the changes required to add more than 2 preheat settings:
[github.com]

Good luck!