MKS Gen L V1.0 - DRV8825

Hello Everyone,

I have bought a board to add it to my custom 3d printer.

MKS Gen L V1.0 Board.
MKS Gen L V1.0 Picture

and i received it without a stepper drivers XD

i bought DRV8825 right now.

I have changed the stepper driver in marlin from A4988 to DRV8825 and i uploaded the marlin to the board.

NOW, do i need to change anything else? im sorry but im toooo young for this coding bla bla bla XD

but at least im trying to do something.

I hope if somebody can support me as usual from this forum.

Thanks a lot

You are never to old or to young to learn. So kudos¹
There are many setting that need to be adjusted for setting up a 3D Printer.

In order to give you the correct information we would need more information, this could be easier if you had a previously configured firmware.
If this is a Home Brew 3D Printer then we would need as much information as you could give about build size, thermisters, End stops, and Proximity sensor ect.....

Was this 3D Printer a complete custom build or from DIY tutorial is is a Prusa i3, CoreXY or Delta there are many different 3D Printer designs an we are in the Blind for helping you.



*¹. praise and honor received for an achievement.

---

Computer Programmer / Electronics Technician

Hi Robert,

Thanks for your reply and i would love to learn more and more.

I made a 3d printer its same or near to Tronxy x5s

I sent u PM of the pic.

its CoreXY type.
Build plate: 235*235mm

ill share with you the configuration.h

The configuration.h file will come in handy for Users wanting to help. Have you done testing of your 3D Printer hardware or firmware to see what if any is in need of calibration.

---

Computer Programmer / Electronics Technician