I'm replacing an original board in a Tripodmaker Black with an SKR 1.3 and I'm going through adding things step by step and have hit a wall. As soon as I enable thermistors in config to a real value, i.e. changing #define TEMP_SENSOR_0 from 998 to 147 the board refuses to start and the TFT controller can't connect. If I change the config value back to 998 (as in setting both #define TEMP_SENSOR_0 and #define TEMP_SENSOR_BED to 998) the board starts and displays the dummy values on the TFT.
Does anyone have any ideas?