Okay folks,
I'm starting to think the old board isn't dead.
After rebuilding the hotend I decided to autotune the hotend again.
I issued,
M303 E0 S200 C8
and
M303 E0 S170 C8

Both times the temp climbed straight up to 220 and 190c respectively and the
pronterface came back with a temp too high error.

Any ideas what is happening? the temp is swinging a too much on the hotend and
I'd rather not have to adjust it by hand.


Many thanks,
Andrew

Edited 1 time(s). Last edit at 01/23/2016 05:47AM by friarfish.

For some reason the first pass of autotune was reaching +35 over the target
temperature.
This was blowing a test in the temperature.cpp file.
I increased the safety margin from +20 to +50c and autotune ran quite happily.