Welcome! Log In Create A New Profile

Z going in reverse on my new Prusa i3

Posted by viper

viper

Z going in reverse on my new Prusa i3
March 10, 2016 11:37PM

Registered: 8 years ago
Posts: 8

When ttying to set level with bed Z runs in reverse Is that my firmware doing this?

Edited 1 time(s). Last edit at 03/10/2016 11:39PM by viper.

Reply Quote

o_lampe

Re: Z going in reverse on my new Prusa i3
March 11, 2016 05:39AM

Registered: 8 years ago
Posts: 5,232

You can turn around the connector of the z-stepper(s) to make it run the right way.

Reply Quote

viper

Re: Z going in reverse on my new Prusa i3
March 11, 2016 10:59AM

Registered: 8 years ago
Posts: 8

I'll try that, thanks

Reply Quote

Newer Topic Older Topic

Print View RSS

Sorry, only registered users may post in this forum.