What is parameter that sets the location where G28 homes Z?

CptanPanic

What is parameter that sets the location where G28 homes Z?
June 17, 2016 12:44PM

Registered: 12 years ago
Posts: 55

I updated my firmware and now z is being homed at 0,0 and not at center of bed like I would like. Which param do I st using latest RC?
Thanks
CP

Edited 1 time(s). Last edit at 06/17/2016 03:29PM by CptanPanic.

Reply Quote

stephenrc

Re: What is paramount that sets the location where G28 homes Z?
June 17, 2016 01:26PM

Registered: 14 years ago
Posts: 548

Make sure Z_SAFE_HOMING is enabled, it's right after the auto-level section.

Reply Quote

CptanPanic

Re: What is paramount that sets the location where G28 homes Z?
June 17, 2016 03:38PM

Registered: 12 years ago
Posts: 55

Quote
stephenrc
Make sure Z_SAFE_HOMING is enabled, it's right after the auto-level section.