I have an AnyCubic Kossel with their 'new' Probe (leveling module), and with their stock firmware its crap.
So I got Marlin1.1.8, modified it for Bilinear Bed Leveling and loaded it and have done, in this order:
Auto Calibration
Set Height
Store Settings
Bed Leveling
Store Settings
Move Z to 0 and adjust height with .2mm calipers.
Apply Difference to Delta Settings -> Height
Store Settings
Print a 160mm dia test circle
The print head raises up on the right rear and digs into the bed at the front left.
It acts like a drunkard on a merry-go-round.
Any ideas what I'm doing wrong??
Thank you!!!
Edited 1 time(s). Last edit at 02/13/2018 09:55AM by DaHai8.