Welcome! Log In Create A New Profile


z axis bottom

Posted by Jamesonmod 
z axis bottom
April 20, 2018 05:00PM
hello all,i'm building a custom printer with the ultimaker structure,now instead of putting the endstop in the upper part of the printer, I would like to put the endstop at the bottom of the printer, so when I start a print the bed should homing before print and then raise at the max height set in the firmware.
I tried with different settings but i cant figure out how to obtain the needed result it's possible and what I need to set in the firmware
Sorry, only registered users may post in this forum.

Click here to login