Unexpected resets and movement along Z (no UBL) April 22, 2018 08:23PM |
Registered: 6 years ago Posts: 12 |
Re: Unexpected resets and movement along Z (no UBL) May 01, 2018 06:00PM |
Registered: 6 years ago Posts: 12 |
Re: Unexpected resets and movement along Z (no UBL) May 01, 2018 06:24PM |
Registered: 6 years ago Posts: 1,863 |
Quote
lmcbmai
I think, I found the problem - while printing this particular part, my XY steppmotors overheat to the level that mainboard resets itself. I reduced driver current and the temperature went slightly down (I can at least touch the motors now), but they are still rather hot. I'm looking into options of attaching temperature sensors, heatsinks and fans to the motors. Then I will switch fans on and off from Raspberry Pi based on temperature readings.