Installed an inductive sensor, but now when homing it raises the Z after triggering the sensor instead of the normal homing operation where it stays at the trigger point.

I've attached my config.h, anyone know what setting I need to change to stop it lifting? I can't tram the bed properly until I can home it at the bed.

I looked into your configuration.h

Though the line I was expecting to have a number has zero, Have you changed this but not flashed to controller!!!!!!!!!!!

#define Z_CLEARANCE_DEPLOY_PROBE 0 // Z Clearance for Deploy/Stow

Some times after flashing you may need to do the flowing procedures.

M502 ; Revert to the default "factory settings."
M500 ; Store parameters in EEProm storage

Edited 1 time(s). Last edit at 05/05/2018 08:00AM by Roberts_Clif.

Ha, I'd played with it just before posting, but haven't had time to flash it to test. Figured I'd ask anyway. I'll flash it tomorrow probably and report back. Thanks for the input.

Edited 1 time(s). Last edit at 05/05/2018 08:20AM by pinkbits.

Flashed with "#define Z_CLEARANCE_DEPLOY_PROBE 0 // Z Clearance for Deploy/Stow" and it's still raising the Z axis after homing.

Anymore ideas?

Run the eeprom clear script 1st (arduino example menu) then reflash

I do that each time. Initialise eeprom to ensure there's nothing wierd in the eeprom from previous firmware.