Hi Guys,

I have been out of the loop for about a year now in the 3D Printing world, only really using my printers at work when needed. Recently i started re-educating myself on current events and noticed that Marlin 2.0 Bugfix is out and supports the MKS SBase (Great work!!). I want to start gearing up to try and get this going on my SBase as i really am not fond of smoothieware, i wondered if someone had already had this setup - if so how is it performing? Also i use the MKS TFT controller, i know this acts as a Host Controller, and if this is currently supported by the Firmware?

Thanks

Alex

Hi,

I would say better check Marlin github, you should be able to get more information here.

Actually this thread give you more details how to compile Marlin 2.0 for your board Marlin 2.0 32-bit thread.

Edited 1 time(s). Last edit at 05/18/2018 03:59PM by xebbmw.

Did you get this Marlin 2.0 up and running on the MKS Sbase and if yes how does it compare to Smoothieware.

---

"A comical prototype doesn't mean a dumb idea is possible" (Thunderf00t)