Welcome! Log In Create A New Profile


Multiple New Issues 2.0 RAMPS/Re-Arm

Posted by 556duckvader 
Multiple New Issues 2.0 RAMPS/Re-Arm
May 19, 2018 09:45PM
I have just started using a BLTouch and it has been working fine since I installed it. Now the BLTouch sometimes doesn’t deploy the probe in the middle of the G29 command. I am also getting more serial disconnects with my Octoprint. I tried printing from the SD card and it gets through the bed leveling process and gets ready to start printing and I got an SD card read error. Also this printer has 373 hours of print time on it. I am trying to figure out where to begin looking for issues. Any help would be great. Thanks in advance.

Edited 1 time(s). Last edit at 05/19/2018 10:10PM by 556duckvader.
Sorry, only registered users may post in this forum.

Click here to login