Welcome! Log In Create A New Profile

Advanced

Change preloaded Firmware Bed dimensions?

Posted by Pekkie85 
Change preloaded Firmware Bed dimensions?
June 30, 2018 10:55AM
Bought an OVM20lite a couple months ago.
cute, cheap, single board ramps spinoff, that, as i just discovered, doesnt seem to be continued. downside: CH340 driver.
came preloaded with Marlin 1.1.1, awesome, cause i'm fixing a chinese crap printer, for a dumbass friend with a luv for aliexpress. never buy that FLSUN crap. or any other asian printer kit.
luckily, the preloaded FW had the temp sensors right, so all i had to do is finetune via EEPROM the steps per mm.
fastest way to get printing again, right?
Now, the preloaded FW has a compiled bed size of 200x200mm, the average I3.
the FLSUN crap, has a bedsize of 270x270mm.
Any way i can change it, without having to down the FW M1.1.1, configure everything, and upload again?
cuz the printer, offcourse, wont move over this FW-set-end-dimensions.

Edited 1 time(s). Last edit at 06/30/2018 10:58AM by Pekkie85.
Re: Change preloaded Firmware Bed dimensions?
June 30, 2018 08:00PM
Nope

That complied in, and not changeable.
Re: Change preloaded Firmware Bed dimensions?
July 01, 2018 10:37AM
thnx
Sorry, only registered users may post in this forum.

Click here to login