Hello!
I am already using dual Z motors with seperate drivers and individual Z endstops for my Tronxy X5S.
One Z endstop connected to Zmin and the other to Zmax. Also I have enabled manual mesh leveling. All good!
I want to add BLtouch ONLY FOR AUTO LEVELLING and not for Z homing.
IMO this type of machine must have individual Z endstops to have the bed level and so I did.
The bltouch will connect to the Xmax or Ymax.
So. here is the help I need. How can I configure the code to use the bltouch only for auto levelling and use the dual Z endstops for homing?
I searched a lot but no luck...
Thanks!
Giorgos
