Welcome! Log In Create A New Profile


Using moving end stops to control stepper

Posted by Coolerooney 
Using moving end stops to control stepper
February 26, 2019 01:23PM
Hi all,

Application is CNC
Want to put the end stop on the moving part-carriage

The end stop is engaged- motor is stopped
When tool gets out of line, the end stops is released and triggers a motor movement (?) then the end stop is triggered and stops the motor . the end stop is released again, by movement of the tool (carriage)- the movement is caused by the material being machined— does the motor restart the ovement?- provide the path is long enough

Or use the enable pin of the driver?



Edited 1 time(s). Last edit at 02/26/2019 01:25PM by Coolerooney.
Sorry, only registered users may post in this forum.

Click here to login