Hi, I have been having some issues with PETG so dragged out my K-Type thermocouple and Fluke-meter. The thermistor I am using is low by a varying degree as the temp goes up. At 235 it is actually only 228 so I have bumped the temp up in the slicer to give an actual 235 hotend.
Just wondering if there is an offset for the temp in Marlin source so I do not have to remember to always bump the temperature up 7% in the slicer.
I also tested 3 more thermostats and they are all off by a small percentage ranging from 5% to 7%.