Welcome! Log In Create A New Profile

Advanced

Inductive probe does not trigger on marlin 2.0 bugfix skr 1.3 board

Posted by totosse 
Inductive probe does not trigger on marlin 2.0 bugfix skr 1.3 board
June 14, 2019 06:29AM
Hello
I have a problem with inductive probe. I had it working before but now i upgraded to skr board and it doesnt trigger.
I switched off pull up resistor, Probe sends signal because if i put it into temperature reading pin, it reads as 94 degrees and -14 when triggering. But when in zmin pin it alsways stays active. If i put Y endstop to zmin pin it works.
I have attached my conf files.
Does anyone have any ideas about why this happens?
Attachments:
open | download - Configuration.h (75.7 KB)
open | download - Configuration_adv.h (87.7 KB)
Sorry, only registered users may post in this forum.

Click here to login