babystepping
July 27, 2019 12:47PM
I tried to setup baby stepping on Marlin 1.1x and getting an error

SENDING:M290 Z0.05
echo:Unknown command: "M290 Z0.05"
SENDING:M290 Z-0.05
echo:Unknown command: "M290 Z-0.05"
'
Has marlin dropped support for baby stepping or is there something more I should be doing.


If I haven’t screwed it up yet, I’m not thinking hard enough!

CoreXY, Titan Aero, Duet WiFi, custom design and build
Cartesian, E3D v6 hotend, Bondtech QR extruder, custom design and build
VDX
Re: babystepping
July 27, 2019 01:02PM
... could be, you have to set a define for babystepping, to enable the M-code ...


Viktor
--------
Aufruf zum Projekt "Müll-freie Meere" - [reprap.org] -- Deutsche Facebook-Gruppe - [www.facebook.com]

Call for the project "garbage-free seas" - [reprap.org]
Re: babystepping
July 27, 2019 02:36PM
In Marlin 1.1.X baby stepping is allowed if it is enabled in configuration_adv.h

#define BABYSTEPPING


Electronics Technician / Computer Programmer
Sorry, only registered users may post in this forum.

Click here to login