which Arduino IDE to be used with Marlin December 26, 2019 12:12PM |
Registered: 8 years ago Posts: 11 |
Re: which Arduino IDE to be used with Marlin December 27, 2019 03:44AM |
Admin Registered: 13 years ago Posts: 6,995 |
Re: which Arduino IDE to be used with Marlin December 27, 2019 11:27AM |
Admin Registered: 11 years ago Posts: 3,096 |
Re: which Arduino IDE to be used with Marlin December 27, 2019 07:22PM |
Registered: 8 years ago Posts: 11 |
Quote
Dust
Don't use anything older than arduino 1.8.9
And don't try to use old marlins older than 1.1.9
Would you please mind to explain this ?- Marlin requires C++11, so anything > 1.6.8 will/should compile proper code.
My 3D-prints were not different while I used older Marlin FW - actually some things are now even worse: the encoder on my SmartController was working very nice before, with 2.0.1 it's almost unusable.
Re: which Arduino IDE to be used with Marlin December 28, 2019 09:22AM |
Registered: 6 years ago Posts: 1,863 |
Quote
marvin42blue
Quote
Dust
Don't use anything older than arduino 1.8.9
And don't try to use old marlins older than 1.1.9
Would you please mind to explain this ?- Marlin requires C++11, so anything > 1.6.8 will/should compile proper code.
My 3D-prints were not different while I used older Marlin FW - actually some things are now even worse: the encoder on my Smart Controller was working very nice before, with 2.0.1 it's almost unusable.
I have been using Marlin 1.1.5 when I upgraded to Marlin 1.1.9BF then Marlin 2 and though the benefits of the upgrades were not very notable. I did a few features that made it worthwhile.
Computer problems be back soon and finish!!!!!!
Sorry about that Upgraded from a 2TB windows 7 OS to a dual 1TB Drive windows 10 OS and having problems with the D: drive, keeps getting lost may need new Cables.
Kept the Windows 7 Hard Drive just in case.
Continuing
#define TEMP_SENSOR_CHAMBER
#define BABYSTEPPING
#define X_DUAL_STEPPER_DRIVERS
#define Y_DUAL_STEPPER_DRIVERS
#define PARK_HEAD_ON_PAUSE
Stepper Drivers easier to use
S-Curve Acceleration
Junction Deviation Factor
Just a few I wanted too experiment with.
Edited 3 time(s). Last edit at 12/28/2019 10:08AM by Roberts_Clif.
Computer Programmer / Electronics Technician