Marlin does not stopping when homing

I have been trying for weeks now with different versions of Marlin to get the endstops to work. Unfortunately I have not been able to succeed until now and would appreciate any assistance on this matter.

Challenge: The machine tries to home however when triggering the endstops they do not stop the motors from running.

Machine Configuration: COREXY

Board used: BTT SKR Pro v1.1

Stepper motor drivers: DVR8825 (Also tried the TMC2208)

When entering the M119 command the endstops show correctly when they are triggered.

I have attached the following files:
- Configuration.h
- Configuration_adv.h
- Version.h

where are XY endstops on your machine?

need to know machine basics...



normally when that happens it is because you have the wrong endstop being triggered.

ie when homeing X, with your configuration.h only Min x endstop will be checked to stop the machine.

I checked the endstops again and found the problem. Thank you for the assistance it is appreciated