Welcome! Log In Create A New Profile


Stuck on Leaving G26

Posted by R3d 
Stuck on Leaving G26
February 18, 2020 09:35AM
I set up UBL and completed all the steps and the last one was to run G26 which ran perfectly with a nice level test print. Now, it's shut off the heaters and the LCD has been showing "Leaving G26" for the last 20mins. The temps are all below 40C at this point but I can't get it to respond to any commands. What can be done so it's not stuck at this point? This is on Marlin v20004.

Edited 1 time(s). Last edit at 02/18/2020 09:36AM by R3d.
Sorry, only registered users may post in this forum.

Click here to login