Welcome!
Log In
Create A New Profile
Home
>
Firmware Folder
>
Firmware - Marlin
> Topic
Advanced
Err: Too far!
Posted by
Rhartl
Forum List
Message List
New Topic
Rhartl
Err: Too far!
August 01, 2020 12:19PM
Registered: 4 years ago
Posts: 41
Why am I getting this error when I try to use Configuration -> Advanced settings -> Set Home Offsets? I am running Marlin 2.0.5.3 on a Monoprice Mini V1 that has been modified to run with a Ranps 1.6 board.
Reply
Quote
Dust
Re: Err: Too far!
August 01, 2020 01:02PM
Admin
Registered: 13 years ago
Posts: 7,000
because offsets are limited to +/- 20
Reply
Quote
Rhartl
Re: Err: Too far!
August 01, 2020 02:46PM
Registered: 4 years ago
Posts: 41
So the z offset is set to some value larger/smaller than +or-20? Is the offset value set in eprom?
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login