Welcome! Log In Create A New Profile


M3 Command

Posted by oldtimmer 
M3 Command
August 18, 2020 11:01AM
Hi All
I am trying to setup a laser on my corexy 3d printer.
Laser GRBL can cut with no problem.
Raster is another storey.
Laser GRBL sends the M3 S0 at the start then just sends Snn after that.
Is there a setting to allow marlin to remember the M3 for the Snn setting.

Thank you

Edited 1 time(s). Last edit at 08/18/2020 11:02AM by oldtimmer.
Re: M3 Command
August 31, 2020 07:42PM
Thank you For all the help.

Found I needed to upload FW version 2.0.6.X
2.0.5 does not have

LASER_POWER_INLINE or LASER_MOVE_POWER (at least for what I could fine)

2.0.6 does
everything works now
Sorry, only registered users may post in this forum.

Click here to login